I found the answer to the Linear Frequency slider, but the Wiki leaves off info for the following, which i need answered:
IT-Compatible Gxx usage
Fast Volume Slides (obsolete?)
Extended Filter Range
IT "old" effects
I need to know exactly what is affected, and when the user may need to enable these...
Hmm. Good question, I'm curious about that
IT-Compatible Gxx:
Gxx, Exx and Fxx share the same effect memory.
Fast Volume Slides:
Scream Tracker has two different volume slide modes. From the ScreamTracker manual:
QuoteFast volslides - Old Scream Trackers had a defective volume slide
command, which slid the volume on every frame. When
set on, the Fast Volslides option will play the
volume slides like the old Scream Trackers. ST3
checks for the version number of the tracker the
.S3M was made on, and if it's older than 3.2, the
fast volslide option will automatically be activated.
Extended Filter Range:
Low/Hipass filter maximum frequency will be doubled. Useful for XMPlay playback because XMPlay will choose modplug's lowpass filter algorithm (which is different from IT's) when this flag is set.
IT old effects:
Some effects are being interpreted as in early versions of Impulse Tracker, for example Tremor (this is not mentioned in the IT manual). Straight from the IT manual:
QuoteDifferences:
The Vibrato (and Tremelo) used in IT is smoother than
how it was implemented in MOD/S3M/etc. It is updated
EVERY frame and hence is independant of song speed,
whereas the standard vibrato WAS dependant upon song
speed. Vibrato is two times 'deeper' with Old Effects
on.
Sample offset commands past the end of a sample in IT
were ignored, whereas with Old Effects on, the sample
is played from it's end point.
All in all: None of them - apart from Extended Filter Range - "need" to be enabled by users.
My brain is swelling with all this excellent knowledge. Thanks, Jojo!
Quote from: "Jojo"IT-Compatible Gxx:
Gxx, Exx and Fxx share the same effect memory.
Explain "effect memory" in relation to these portamento effects.
Also, i noticed that the "fast slider volume" option was always disabled no matter what format i chose in Song Properties. Is it only enabled when loading an .s3m file?
If you use the value 00 for any effect, it means it will use the previous known value.
Example:
G10
G00
G00
equals
G10
G10
G10
I will now give you an example with on and off.
E02
G10
G00
G00
E00
E00
with on, it results in:
E02
G10
G10
G10
E10
E10
with off it results in:
E02
G10
G10
G10
E02
E02
I hope this makes sense. :)
QuoteIs it only enabled when loading an .s3m file?
As ST3's manual says, it's only there to enter the "quirks" mode of old ST3 versions. So it doesn't make sense in any other format, and it should not be enabled.
BTW, it's also worth mentioning that the Exx and Fxx memory are always linked, just the Gxx memory is not always linked.
BTW 2: LPChip got it wrong: Gxx memory is only linked when the flag is set
off - Also, this doesn't work if "it compatible mode" is disabled.
Eh... Just a typo :nuts: :lol: